This month we took on a project to remove and replace the original OEM integral insulation with our own solution. In the picture below, the OEM is on the left and our replaced solution on the right.
We also looked to try and improve the insulation areas by extending the covered areas towards the outlet flange.
After fully insulating both manifolds we carried out some temperature testing to ensure our product was going to reduce our customers engine bay temperatures. With the image below, it can be seen that our insulation is giving a 72% surface temperature reduction at the point of the X.
To find out if we can assist you in thermal management then please leave us a message on our contact page. We will be happy to go through our solutions with you.